![]() In the surface test, you test each drive sector or memory block for the read/write response. If you can access the drive, back up your files immediately. Function > Health Status Warning > Threshold of Caution. How to Fix Uncorrectable Sector Count Warning. This is less than 41, so its health score remains at 100. I dont think the absolute static value is as important as how it changes over time. So that means that the drive loses 1 point for every 41 sectors (= 1716 / 41 ).ĭrive D: has recorded 16 (= 0x10) reallocated sectors. This means that it has lost 41 points (= 100 – 59). I used the program Crystaldiskinfo on my three year old laptop disk. If we take drive F: as an example, we see that it has developed 1716 (= 0圆B4) reallocated sectors. When this score drops below the threshold, the drive is considered to have failed. When the drive begins to develop bad sectors, the health score declines. These particular attributes begin life with a health score of 100%. Am I reading this incorrectly? The raw values show a difference though.Īnswer:ISTM that the OP is having difficulty understanding the normalised values of each attribute (Current / Worst / Threshold). Looking at the data from the program it looks like the Current and Worst for Reallocated Sectors Count, Current Pending Sector Count, and Uncorrectable Sector Count are the same from the Primary Data drive (D) to the Primary Backup drive (E) but D is flagged as Caution. ![]() ![]() My primary data drive and secondary backup drive are showing Caution, but I am having trouble understanding the results as the results appear to be the same between my primary data drive and my primary backup drive but one shows caution and the other shows good. But there are only a limited number of sectors available for this purpose and I expect that number has long since been exceeded. Question: I recently felt my computer was running slow when accessing data on the hard drives and the data on the hard drives was getting slower to populate so I decided to run some health checks and ran CrystalDiskInfo to check my hard drives out. The 'Reallocated sectors count' is the number of sectors thus replaced.
0 Comments
Leave a Reply. |